Network configuration
How to enter the numbers
To move the selection and change the values, use the pointers ▲/▼/▲ projector or on the remote control handset.
The ▲ / ▲ keys are used to move the selection item. The ▲/ ▼ keys are used to change the number value.
/ | ▲ | on the |
|
3 Restart the Network board
Select the SET with ▲ / ▲ keys and press the SELECT button again. The net- work configuration display disappears and the network board begins restarting*1. It takes about 60 seconds. Do not turn off the mains switch during this period.
Completing of installation
Now the installation is completed. The IP address of this projector was set to “192.200.1.201”. Next, please see chapter “Basic setting and operation” on page 25. It describes basic setup and operation of the projector.
Password setting menu [Display]
A password can be set to restrict access to the setting pages of the projector using the web browser. The default password is set “0000” as no password.
Use the projector’s menu and select the Display icon on the Setting sub menu, and then press the SELECT button on the projector twice. The following setting display appears on the screen. The numbers on the display indicate the current password. To change the password, enter your desired number by using the pointers on the projec- tor or remote control handset, and then Select the SET with ▲ / ▲ keys and press the SELECT button. The password setting display disappears and the network board begins restarting*1. It takes about 60 seconds. Do not turn off the mains switch dur- ing this period.
Password |
|
|
|
|
|
|
|
|
|
0 |
| 0 | 0 | 0 |
| ||||
|
|
|
|
|
|
| |||
|
| SET |
|
| CANCEL |
| |||
|
|
|
|
|
|
|
|
|
|
*1 The network board begins restarting automatically when the network configuration or pass- word setting is changed and then the SELECT button is pressed.
✐Password setting must be done when you connect the projector to the network. This setting is carried out through the projector’s menu and also it can be set through the network using the web browser. For further information please refer to chapter “Initial Setting/Password setting” on page 30.
✐Valid characters for password are 4 digits numeric numbers 0 to 9.
✐This password is not to restrict the use of the projector. This password is to set the security against the use of the projector through the network.
Network Board
OWNER’S MANUAL
ENGLISH
17
