Electrolux EKC60752 user manual The anti-tip guard, How You Fix The Anti-Tip Guard To The Cooker

The anti-tip guard

The anti-tip guard must be fitted to prevent the cooker from tipping over with abnormal loads.

The anti-tip guard only works when the cooker has been pushed into place.

HOW YOU FIX THE ANTI-TIP GUARD

TO THE COOKER:

1Before fitting the anti-tip guard, make sure that the cooker has been adjusted to the correct height and is standing level (see page 7).

2The attachment (B) is fitted to the left side when delivered. Measure out where the anti-tip guard (A) is to be located, 60 mm (2.4") down from the edge of the ceramic glass plate and 50 mm (2.0") from the wall(cupboard). Screw it firmly into solid material or use suitable reinforcement. The entire anti-tip guard (A+B) can also be located on the right-hand side (SEE FIG. 1).

Make sure that the surface behind the cooker is smooth. If there are tiles or a moulding behind the edge of the ceramic glass plate then there must be a space with the same dimension between the anti-tip guard and the wall. This is so that the anti- tip guard is firmly attached to the cooker and functions correctly.

Check that the anti-tip guard projects at least 20 mm (0.8") into the hole in the back of the cooker (B) when the cooker is pushed in (SEE FIG. 2).

NOTE! If the space between the bench cupboards is greater than the width of the cooker, then you must adjust the side measurement if you want to centre the cooker..

1

2

8