Electrical connections
Any work required on the cooker must be carried out by a QUALIFIED EXPERT. Any work carried out by
The electrical installation is to include a device whereby it is possible to separate all the poles of the equipment from the power supply, with a contact opening of at least 3 mm.
This requirement must be satisfied for safety reasons.
The connected rating and voltage are shown on the data plate. There is a wiring diagram on the back of the cooker.
Decor plinth (optional accessory)
NOTE! Take due care when fitting the base trim to the cooker. Edges with which you do not normally come into contact with can be sharp.
NOTE! ONLY FITS COOKERS WITH A HEIGHT
OF 900 MM (35.5").
Remove the protective plastic before use.
1 Remove the drawer from the cooker by lifting it diagonally upwards and then pulling it all the way out.
2 Fit the base trim by pressing it firmly onto the base (snap fastener, no tools needed).
3
Bild 5
9