EMC 300-000-978 REV A03 manual Installing PowerPath, Start the installation program. Enter

1

Installing PowerPath

Installing PowerPath 4.0

This section describes how to install, or reinstall, PowerPath 4.0 when no earlier version of PowerPath has been installed on the host.

If you are upgrading to PowerPath 4.0 from PowerPath 3.0.x or 2.1, refer instead to Upgrading to PowerPath 4.0 on page 1-10.

Mount the CD-ROM1. Log in as root.

2.Insert the CD-ROM into the CD-ROM drive.

If the CD mounts automatically, continue with Install the Software, which follows.

If the CD does not mount automatically, you must mount it manually. Continue with step 3.

3.Mount the CD on your file system. For example, to mount the CD on /cdrom/cdrom0, enter:

mount -F hsfs -r /dev/dsk/cxtydzs0 /cdrom/cdrom0

where x, y, and z are values specific to the host’s CD-ROM drive. For example:

mount -F hsfs -r /dev/dsk/c0t2d0s0 /cdrom/cdrom0

Install the Software 1. If you do not have a graphics terminal, run the script filename command to record pkgadd output in the specified file. (After pkgadd completes, use CTRL-Dto stop recording the output.)

2.Change to the /mount_point/UNIX/SOLARIS directory. For example, enter:

cd /cdrom/cdrom0/UNIX/SOLARIS

3.Start the installation program. Enter:

/usr/sbin/pkgadd -d .

1-6 PowerPath for UNIX Installation and Administration Guide