EMC 300-000-978 REV A03 manual Remove, Reboot the Host

Installing PowerPath

3.Enter the PowerPath registration key and press ENTER.

If you entered a valid key, you see the following output:

1 key(s) successfully added. Key successfully installed.

Key (Enter if done):

4.Press ENTER. You see the following output:

1 key(s) successfully registered.

Registering PowerPath after you install the software and before you reboot the host sets the appropriate default load balancing and failover policy. If you reboot the host before you register PowerPath, you must run the powermt set policy to reset the load balancing and failover policy. Refer to the PowerPath Product Guide or the powermt(1) man page for more information on powermt set policy.

Remove the	1. If the CD-ROM volume management daemon vold is running,
CD-ROM	unmount and eject the CD-ROM. Enter:
	eject
	and remove it from the drive.
	2. If vold is not running, unmount the CD-ROM. For example,
	enter:
	umount /cdrom/cdrom0
	and, after the CD-ROM unmounts, eject it and remove it from the
	drive.
Reboot the Host	Reboot the host. Enter:
	reboot -- -r
	Registering PowerPath after you install the software and before you reboot
	the host sets the appropriate default load balancing and failover policy. (Refer
	to Register PowerPath on the Host on page 1-16.) If you reboot the host before
	you register PowerPath, you must run the powermt set policy to reset the
	load balancing and failover policy. Refer to the PowerPath Product Guide or the
	powermt(1) man page for more information on powermt set policy.

After You Install 1-17

1