Rosemount 4500
Reference Manual
Review Configuration Data
Fast Keys | 1, 5 |
|
|
NOTE
Information and procedures in this section that make use of HART Communicator fast key sequences and AMS assume that the transmitter and communication equipment are connected, powered, and operating correctly.
HART Communicator
Before placing the transmitter into operation, review the transmitter configuration data below which was set by the factory.
Manufacturer “Rosemount” | |
|
|
Transmitter model | Drain/Vent material |
Measurement type | Number of diaphragm seals |
|
|
Module configuration type | Seal type |
Range | Remote seal isolator material |
|
|
PV Unit | Seal fill fluid |
PV Lower Sensor Limit (LSL) | Tag |
|
|
PV Upper Sensor Limit (USL) | Date |
PV Lower Range Value (LRV) | Descriptor |
|
|
PV Upper Range Value (URV) | Message |
PV minimum span | Write protect |
|
|
Lower sensor trim point | Meter type |
Upper sensor trim point | Local keys |
|
|
Sensor trim calibration type | Universal revision |
Transfer function | Field device revision |
|
|
Damping | Software revision |
Alarm direction | Hardware revision |
|
|
High Alarm (Value) | Physical signal code |
Low Alarm (Value) | Final assembly number |
|
|
High saturation | Device ID |
Low saturation | Burst mode |
|
|
Alarm/Saturation type | Burst option |
Sensor S/N | Poll address |
|
|
Isolator material | Number req preams |
Fill fluid | Multisensor device |
|
|
Process connector | Command #39, EEProm Control required |
Process connector material | Distributor |
AMS
Right click on the device and select “Configuration Properties” from the menu. Select the tabs to review the transmitter configuration data.
