Emerson MPR25 Installation and start-up procedures, Tools and test equipment, Step, Action

41

Installation and start-up procedures

Tools and test equipment

The following tools and test equipment are required:

•Potentiometer screwdriver Bourns Inc. No. 32

•Potentiometer screwdriver Bourns Inc. No. 60

•Screwdriver 3 inch

•Digital voltmeter - Fluke 8000 A or equivalent

•Dummy load

Installation procedure

Procedure 1 - Power shelf installation

Step	Action
1	Position the power shelf against the rack.
2	Fasten the shelf in the position indicated on the drawings (normally
	directly below the Controller or below another power shelf).
3	Release the clamping bar from the front of the power shelf (Refer to
	Figures 10, 11 and 12).
4	Remove the AC junction box cover (left side) and store for re-
	installation.
5	Remove the DC and control wiring area cover (right side) and store for
	re-installation.
	–end–

25A Switch Mode Rectifier NT5C06B / C Installation and User Manual