Emerson MPR15 Series HVSD adjustment, Embedded shelf quick disconnect for sense sectional view

62 Installation and start-up procedures

Figure 24 - Embedded shelf quick disconnect for sense (sectional view)

HVSD adjustment

Procedure 12 - HVSD adjustment

Step	Action
1	Turn the HVSD potentiometer fully clockwise.
2	Monitoring the test points (V+, V-), adjust the float potentiometer FLT to
	the desired HVSD level.
3	Turn the HVSD potentiometer slowly counterclockwise until the rectifier
	shuts down. The test point voltage shall start decaying to 0 volt.
4	Turn the float potentiometer counterclockwise, two full revolutions.
5	Cycle the AC breaker OFF/ON. The unit shall power up with the return of
	the float voltage on the test points.
6	To verify turn the float potentiometer slowly clockwise until the unit
	shuts down. Read the float voltage to verify the disable point. Turn float
	potentiometer counterclockwise, two full revolutions. Cycle the AC
	breaker OFF/ON.
7	Re-adjust if needed (return to step 1).

–end–

UM5C06B / C ( 169-2071-500 ) P0711722 Standard 10.00 May 2001