Emerson NT5C06D user manual A0384387

26 Installation and start-up

Figure 7 - No controller, remote sensing connection for 8-pin signal cable shelves

Note 1: Refer to MS5C06 for available 8-pin ribbon signal cables of different lengths to connect from the shelf back plane rectifier position to the remote sensing point.

Note 2: Identify the wire color corresponding to RG+ pin 2 and RC- pin 3 to be used for the remote sensing. Completely cut out completely the 8-pin connector, leaving the signal wires loose. Insulate each unused wire with electrical tape. Use the pin references to identify the signals as described above.

Note 3: Use #20 AWG (105°C) wire.

Note 4: Use 1.6A fuse A0384386 with ferrule type fuse holder

A0384387.

UM5C06D ( 169-2071-504 ) P0831010 Standard 7.00 May 2001