Emotiva DMC-1 manual Step, available and it is highly recommended, DISTANCE menu

Step

15

Step

16

NOTE: you can quit the OSD at any time by pressing EXIT on the remote. Any changes you make will be saved. There is no need to navigate back through previous pages, unless you want to make more changes.

When the OSD is active, the DMC-1 front panel display shows an abbreviated message of where you currently are in the menus.

Step 15 - In the MAIN Menu, select the SETTINGS Menu, and then the SPEAKERS Menu.

��������

Step 16 - In the SPEAKERS Menu, select the SIZE Menu.

Use the joystick pad to set the size of each speaker to Small or Large, or set to OFF for those speakers which are not present. Return to the SPEAKERS Menu when you are finished.

Step 17 - In the SPEAKERS Menu, select the CALIBRATION Menu to adjust the output of each speaker.

	A test noise plays in each selected speaker, and you use the
	remote to adjust the volume of each speaker until they are
	all playing at the same level. Return to the SPEAKERS Menu
	when you are finished. This task can be made easier and more
��������	accurately with a low cost sound level meter. Radio Shack
	and other local suppliers will have this type of product readily
	available and it is highly recommended.
	Step 18 - In the SPEAKERS Menu, select the SPEAKER
	DISTANCE menu.
Step
17	Enter the distance from your listening position to EACH
	speaker. It will be handy to use that measuring tape to get
	as close as possible. Don’t sweat a few inches, but being off by
	a foot or more will compromise the system’s ability to create
	the a cohesive sound field.
	Step 19 - If you play a Dolby Digital or DTS encoded source,
	the DMC-1 will automatically select the correct surround

mode. If it is a 2-channel source, you can select a surround mode using the remote’s MODE buttons or from the front panel.

Page 41