Emotiva DMC-1 manual 5Z II Zone, 6Input Select Buttons, 8AM/FM Tuner Controls, 9Tone Controls

5Z II (Zone 2)

Any changes you make after pressing this, will affect Zone 2 and not the Main Zone. For example, press Z II, then POWER to turn on Zone 2, then adjust the Volume and select an input. Press Z II again to revert back to Main Zone operation. It will also revert back after a short period of no activity.

Note: If Zone 2 has not been enabled this button has no effect. The unit is shipped with Zone 2 disabled.

time. If held down for a second or more, the tuner will automatically keep tuning stations. Press UP or DOWN once again to stop when it reaches a station you like.

Preset Tuner Memory Buttons

1-9, 0, +10 -These buttons are used to directly select your favorite stations, previously stored as presets.

6Input Select Buttons

Use these controls to select the source that you want to listen to and/or view. Using the On Screen Display (OSD) INPUTS menu, each input can be adjusted in level so that all the inputs have similar volumes. Each input can also be set to enter a desired surround mode whenever that input is selected.

Note: After you have selected an input, you should check that the DMC-1 is set to the desired surround mode (or the stereo mode).

7MODE UP/DOWN (Mode Buttons) These buttons allow you to step up or down through the various sound playback modes.

8AM/FM Tuner Controls

The AM/FM button toggles between the AM or FM band. Press and hold it to scan of the station presets. Press it again or press a preset button to stop the scan.

DIRECT Tuner Controls

Use this to enter a station’s frequency directly using the 0 - 9 keys, such as 9, 3, 9 for 93.9 MHz.

UP/DOWN Tuner Controls

Switch to stations above or below the frequency of the current station. If repeatedly pressed, the tuner will move up or down one frequency step each

9Tone Controls

To change the tone, first press BASS or TREBLE and then press UP or DOWN to suit your taste. The display will show the change in dB level for reference. The range for both BASS and TREBLE is +/- 10 dB in steps of 1 dB. The unit returns to its normal display after a few moments of inactivity, and any level changes are retained.

The BASS and TREBLE levels can also be adjusted using the OSD TONE Menu and the remote control.

Note: The Tone controls do not affect the LFE channel, or the 8-Channel analog input.

10Signal Processing Indicator Lights

DOLBY DIGITAL

This light is on when a Dolby Digital signal is being decoded.

DTS

This light is on when a DTS signal is being decoded.

DOLBY PRO LOGIC IIx

This light is on when the Dolby Pro Logic II or Pro Logic IIx mode is engaged.

DIGI

This light is on when a digital audio signal is being decoded.

Page 15