Emotiva DMC-1 manual Punch, Setup Erase, Light

Models: DMC-1

1 96
Download 96 pages 37.91 Kb
Page 47
Image 47
SETUP.

PUNCH

This mode allows you to set up the volume, channel up/down and transport buttons so they will work for your main devices, no matter which device the remote is set for. For example, the volume buttons can operate the TV, even if the remote is set to VCR. The channel buttons can operate the VCR, even if the remote is set to TV.

1)In SETUP, select PUNCH and the display changes to show VOL, CH, and PLAY. The PLAY selection will make the eight transport buttons around the joystick “punch” through.

2)Select one of these buttons, for example VOL.

3)Press a device button for the device you want the Volume commands to appear in (punch TO).

4)Press a device button for the device you want to learn from (punch FROM). These settings are saved.

5)Repeat steps 2 to 4 until you have punched to all devices you want.

6)Use MAIN to return to SETUP.

NOTE: To erase Punch commands from a device (return buttons to their previous programming): Repeat steps 1 and 2, then press the device button twice. Repeat for other devices, then press MAIN to return to

SETUP.

ERASE

Use this mode to erase commands stored in the remote. This does not affect the labels, just the stored IR commands. The pre-programmed commands for the DMC-1 can be lost. Please follow this section CAREFULLY!

1)In the SETUP mode, select ERASE and the display will show LEARN, FAV, MACRO and EXIT.

2)If you select LEARN, press ALL to erase all learned buttons, or KEY to erase one device at a time. If you use KEY, press MAIN and EXIT when you have erased all the devices you want. NEVER select

ALL! This will erase the EMO operating codes and the remote will have to be sent to the factory for re-programming.

3)If you select FAV, press ALL to erase all favorites, or KEY to erase single favorites. Note that the labels are not erased.

4)If you select MACRO, press ALL to erase all macros, or KEY to erase macros, one device at a time.

5)Press EXIT to return to the SETUP menu, and press MAIN to return to the main device menu.

LIGHT

This mode allows you to either disable the light, or change the number of seconds it stays on. (The light is inactive while in the SETUP mode).

1)In the SETUP menu, select LIGHT and the display will show ON, time in seconds, SAVE and EXIT.

2)If you press ON, it changes to OFF and disables the light. This is useful if you want to save battery life, or if you have children who like to use the remote as a flashlight.

3)Use the keypad to enter the amount of time (in seconds) in which you wish the light to remain on after releasing the light button. If you enter 00, it only stays on while the light button is held down.

Page 47

Page 47
Image 47
Emotiva DMC-1 manual Punch, Setup Erase, Light