Emotiva DMC-1 Speakers Menu Calibration, Use the OSD to navigate to the Speaker Calibration menu

SETTINGS Menus (Continued)

SPEAKERS Menu - CALIBRATION

The calibration procedure allows you to adjust the volume level of each speaker in turn until they are all equal. This will give you the best Home Theater performance. You should only do this calibration when you are sitting in your usual listening/viewing position.

��������

Preliminary: Play a movie and adjust the volume for a comfortable listening level. The volume of the calibration test noise is linked to the setting of the main volume control, so if the test noise is too quiet, turn the main volume up a

little and retry.

1)Use the OSD to navigate to the SPEAKER CALIBRATION menu.

2)Press the remote’s joystick down to turn on the noise generator. While the test signal is playing in

each speaker, its level can be adjusted using the joystick left/right buttons. Adjust each speaker in turn until they are all equal in volume.

SPEAKER POSITION LEVEL (in dB)

LEFT MAIN SPKR

CENTER SPKR

RIGHT MAIN SPKR

RIGHT SIDE AXIS

RIGHT SURROUND

RIGHT SURR BACK

LEFT SURR BACK

LEFT SURROUND

LEFT SIDE AXIS

SUBWOOFER

The best results are obtained if you use a Sound Pressure Level (SPL) Meter. This is a hand held meter which will accurately measure and display the sound level. Adjust all of the speakers until they are playing within 1 dB of each other. Without a meter, you can still obtain good results with careful listening.

3)Repeat the procedure several times for each speaker until you are satisfied they are playing at the same level.

4) Press the joystick UP to return to the top of the menu, and then press joystick LEFT to exit. The calibration noise generator will turn off.

The main volume control adjusts the volume of all of the speakers up and down at the same time. They keep the same relative levels you in this menu.

Page 59