NOTE: This connection is required for setting up initial configuration information. After configuration is completed, the
Step 5 Attach one straight Ethernet cable to the Power & Data Output Port on the Inline Power Injector(refer to page 5).
Step 6 Plug the other end of the straight Ethernet cable to the Ethernet Port (refer to page 5) on the Wireless client bridge.
When the Wireless client bridge receives power over the Ethernet cable, the Wireless client bridge will start its boot sequence and the Active LED on the Inline Power Injector will light up.
You can configure the Wireless client bridge via HTML browser, such as Microsoft Internet Explorer or Netscape Navigator from a remote host or PC.
2.4Basic Configuration
2.4.1 What you need to know
The Wireless client bridge can be configured into two operation roles, including Wireless Client Bridge and Wireless Client Router.
The Wireless client bridge is shipped with default configuration to function as a client bridge between an Ethernet and Wireless network by attaching Wireless client bridge to the wired LAN simply. If user would configure Wireless client bridge, please refer to the following procedures.
2.4.2 Basic Configuration Steps
This section describes a
Step 1 Select an operation mode for Wireless client bridge on the web page “/General Config/System/”, and click FINISH to refresh this page.
Step 2 Modify the
Config/System/”, and click FINISH to save the changes.
Step 3 Modify the
Step 4 (Optional) Modify other parameters on the web page “/General Config/”, and click FINISH to save the changes.
Step 5 Move to page “/Utility/Administration/”, select the | Save |
then Restart and then click FINISH to take effect on the previous configuration changes.
Version 1.02 | 8 | Version 1.02 | 9 |
