EnGenius Technologies IEEE 802.11b Outdoor Wireless Client Bridge „ Radiation Exposure Statement

7.2Utility

7.2.1 Software Upgrade

Chapter 8. Regulatory Compliance Information

„Radio Frequency Interference Requirements

Parameter

TFTP Server IP Address

Upgrade Filename

Description	Default Value
Specify the IP address of the	192.168.2.100
TFTP server to upgrade the
firmware of the RB
Program Image	SUSW.Bin
Web Image	SUFS.Img

This device complies with Part 15 of FCC Rules and Canada RSS-210. Operation is subject to the following conditions:

This device may not cause harmful interference.

This device must accept any interference received, including interference that may cause undesired operation.

„Radiation Exposure Statement

7.2.2 Administration

Parameter	Description	Default Value
Supervisor ID	Supervisor’s identity code	root
Supervisor Password	Supervisor’s password	root
Password Confirm	Confirm the password again	root

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body.

This transmitter must not be co-located or operating in conjunction with any other antenna of transmitter.

„Interference Statement

This equipment has been tested and found to comply with the limits for a Class C digital device pursuant to Part 15 of the FCC Rules and Regulation. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to nearby TV’s, VCR’s, radio, computers, or other electronic devices. To minimize or prevent such interference, this equipment should not be placed or operated near these devices. If interference is experienced, moving the equipment away from them will often reduce or eliminate the interference.

However, there is no guarantee that interference will not occur in a particular installation. If the equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Re-orient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Version 1.02 48 Version 1.02 49