6.BASIC OPERATION

6.3 Fast Feeding of Chart Paper

When pressing FEED , chart is fed at the speed of about 0.1mm/sec. When pressing FEED more than 1 sec, chart is fed at the speed of about 10mm/sec.This operation is used for the following purposes.

(1)Setting the time scale line of the chart paper

(2)Checking of chart paper feeding operation

Remarks Fast feeding condition and operation

1.Condition ….. (1) For the fast feeding of the chart paper, the status KEY LOCK should be gone out.

(2)This function cannot be executed during printing.

2.Operation …..Digital data printing is not executed during the fast feeding of the chart paper.

This function can be executed when the printing is off (RECORD ON goes out.).

Reference 1 Manual chart feeding

Pull out the chart paper cassette slightly from your recorder. Turn the thumb wheel on the left side of the drum.

Thumb wheel

(Gear)

RD200

RD2800

Thumb wheel

(Gear)

Note: Even if the time scale line is set by manual chart paper feeding, a delay may occur due to the back lash of the thumb wheel (gear).

Remarks 2 Time scale (1 to 24)

Numeric values of 1 to 24 are marked on the left side of the chart paper. These are time scales when operating the printing at a chart speed of 20 mm/h for RD200 or 25mm/h for RD2800.

-29-

Page 33
Image 33
Omega RD2800 Fast Feeding of Chart Paper, Remarks Fast feeding condition and operation, Reference 1 Manual chart feeding