Omega RD200 Printing Format, 14.1ProgrammingAutomatic Range-Shift Printing, Automatic Range-shift

14. PRINTING FORMAT

14.1ProgrammingAutomatic Range-Shift Printing

This programming display only appears for the printing format (option). This programming is to change the trace printing range automatically.

1 Automatic Range-shift

The automatic range-shift function changes the trace printing range up to 5 stages according to the measured values.

(1)This programming can be applied to each channel.

(2)The total printing range can be programmed optionally irrespective of the programmed range in the [Range/Printing range].

(3)For each range, refer to the minimum printing range in section 22.1 (Input Specifications). The printing may be dispersed if each range is programmed to be less than the minimum printing range.

(4)The range shifting is executed when the measured value exceeds approx. 0.5 mm from the minimum (zero) or the maximum (span) range.

<Example> Automatic range-shift programming

<Range No. 23 (K thermocouple)>

	-200		Measuring value						1370
		1st range			2nd 3rd				4th range
					range		range
		(R1)			(R2)		(R3)		(R4)
Total printing -
				400		600		800	1200
range	100
Printing range (1)									(2)
for 1st range -100									400
Printing range									(3)
for 2nd range(400)									600
Printing range									(4)
for 3rd range(600)									800
Printing range									(5)
for 4th range(800)									1200
Mark	is the programming point and No. (1) to (5) shows
the order of programming. By pressing								ENTRY when the

programming ends, the screen moves to the next programming screen. As No. 5 is not used in this example, only press ENTRY .

2 Programming Mode

1) Screen 1 (Printing format check)

  		 
Standard	Automatic	Zone
	range-shift	Compressed/expanded

Dots appear at the selected format.

By pressing SET , the dots disappear and the

END

cursor appears instead.

2) Screen 2 (Programming channel)

Automatic range selection



Channel Cursor

By selecting automatic range-shift (), the cursor appears at the channel programming position.

3) Screen 3 (Zero programming at No.1 range)

Range No.	Zero
  	 

Programming value

(Max. 5 digits by left-justify)

(1)The default programmed value is the minimum value in the [Range/Printing range]. This programming can be changed as required.

(2)When all programming are completed, return to the above display and execute [Storing].

4) Screen 4 (Span programming at No. 1 to 5 ranges)

Range No. Span

  

Programming value

(Max. 5 digits by left-justify)

(1)When the programming a span, the range number advances. Program the span up to the required range number.

(2)After pressing ENTRY up to range No.5, press ENTRY again to return to Display 3.

－９２－