11. OTHER PROGRAMMING
11.8 Engineering Units
Engineering units up to 5 digits can be assigned for digital data printing and scale printing.
Press | SHIFT and | 3 | simultaneously to display [Engineering unit] programming screen. | |||||||
UNIT | ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Examples単of位engineering印字の例 | unit printing |
|
| ||
| (Digital data printing) |
| (Scale printing) |
| (List printing) | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1
In case no engineering unit is programmed;
An engineering unit is decided by the range number programmed in the [Range/Printing range] programming.
Voltage range | Temperature range | |||
|
|
|
| |
mV | V | °C | K | |
(Nos. other than ones | ||||
(01 to 05) | (06 to 10) | (47, 80) | ||
shown on the right) | ||||
|
|
| ||
2
Programming Mode
|
| (Fixed) | Cursor | |
Engineering unitcharacter | ||||
| ||||
*1 |
|
| ||
Channel | Digit No. of engineering unit character *2 |
|
|
|
|
| |
| (Up to 5 digits.) |
|
|
| (Numeric numbers (1 to 5) appear for the digit not programmed by pressing | ° | .) |
|
| F |
|
*1: Engineering unit character
The character at the digit where the digit number is pointed by the cursor is displayed.
*2: Digit No. of engineering unit character
A digit No. 1 to 5 is displayed by pressing °F .
<To decrease the digit No.>
Press SHIFT and 0 simultaneously to clear the digit No. and press °F for reprogramming a
CLEAR
new digit No.
If the range No. is changed;
A programmed engineering unit is deleted and the engineering unit determined by the range No. is displayed
If clear is stored at scale programming;
If the scale is cleared in a channel; the engineering unit of this channel is deleted, and it becomes the engineering unit determined by range No.
－６９－
