5. INSTALLATION

5.1 Chart Paper Loading (RD200)

3Chart Paper Setting

1)Draw out the chart paper approx. 20 cm and close the rear stripper plate.

2)Set the holes on the chart paper over the sprockets at both ends of the drum.

3)Use the thumb wheel to advance the chart paper for 2 to 3 folds into the chart tray.

4)Close the front chart paper guide. Make sure that the holes are set over the sprockets.

Set the holes on the chart paper to the sprockets.

Remarks Chart paper folds

Don’t insert the chart paper folds reversely when inserting the chart paper into the chart paper tray, otherwise a folding failure results.

Folding section

Chart paper

4Check

1)Manual check

Turn the thumb wheel by hand to make sure that the chart paper is feeding properly.

Remarks Turningdirectionofthumbwheel

Don’t turn the thumb wheel inward. The chart paper cannot be fed backward. This action may cause a chart paper feed failure.

Thumb wheel

(Top view)

2) Place the chart paper cassette in its original position

Place the chart paper cassette with the chart paper loaded in your recorder.

(1)Guide rails for the chart paper cassette are located on the right and left side of the internal unit. Set the guides of the chart paper cassette to the guide rails and push it until it clicks into place.

(2)Return the keyboard back in its original position.

3)Chart paper feeding check

(1)Turn on the power supply.

(2)Press the FEED key and check the chart paper feeds smoothly.

(3)Repeat the above procedure if the chart paper is not fed smoothly.

4)Operation during chart end detection

When the chart paper cassette is returned in the internal unit during the chart end detection, the CHART END display blinks. Press ENTRY to turn it

from blinking to steady lighting.

Press ENTRY again. The CHARD END display goes out and the chart paper is fed automatically.

-22-

Page 26
Image 26
Omega RD200, RD2800 manual Chart Paper Setting, Check, Remarks Chart paper folds, Remarks Turningdirectionofthumbwheel