EnGenius Technologies IEEE 802.11b Outdoor Wireless Client Bridge user manual

„IP Use MAC Addr.

You can choice Enable or Disable. If you choice Enable , it will set IP = 10.X.X.X that used to last 3 MAC Address ID.

For example :

MAC Addr = 00:47:55:43:43:49 => IP = 10.67.67.73(43hex=67decimal) If you choice Disable you need setting Bridge IP Address Information.

„Bridge IP Address

Use this setting to assign or change the Wireless client bridge IP address.

„Bridge Subnet Mask

Enter an IP subnet mask to identify the sub network so the IP address can be recognized on the LAN.

„Default Gateway IP Address

Enter the default Gateway IP Address, and click FINISH at the bottom of this page to complete the modification of this page.

2.4.5 Set Wireless Encryption for Wireless Interface

The Wireless client bridge supports 64-bit and 128-bit WEP encryption.

For 64-bitWEP encryption, an encryption key is 10 hexadecimal characters (0-9 and A-F) or 5 ASCII characters.

For 128-bitWEP encryption, an encryption key is 26 hexadecimal characters or 13 ASCII characters.

Modify the WEP encryption parameters on the web page “/General Config/Woreless/”. Enter 1~15 characters into the WEP Key field, and click KeyGen to generate the WEP64 or WEP128 key patterns.

2.4.6 Change Supervisor Account & Password

Enter the Utility > Administration page. The figure below shows the Utility/ Administration page.

„Supervisor Account

Change the supervisor’s user name and password in the Supervisor Account field, and click FINISH to take effect on the previous configuration changes.

„Apply the New Settings

Step 1 Enter the Utility > Administration page, select the Save then Restart to apply the new configuration settings.

Step 2 Click FINISH to take effect on the previous configuration changes.

Hint: It takes about 10 seconds, to complete the restart process.

Version 1.02 14 Version 1.02 15