Enterasys Networks Enterasys Switch Configuration Guide and Troubleshooting for B3G124 Models

Using the Reset Switch

Table 4-2 Troubleshooting Checklist (continued)

Problem	Possible Cause	Recommended Action
Port(s) goes into	Loop condition detected.	Verify that Spanning Tree is enabled. Refer to the
standby for no		SecureStack B3 Configuration Guide for the instructions to
apparent reason.		set the type of STA.
		Review the network design and delete unnecessary loops.
		If the problem continues, contact Enterasys Networks for
		technical support.
User parameters	Clear NVRAM was set using	Reenter the lost parameters as necessary. Refer to the
(IP address, device	CLI commands.	SecureStack B3 Configuration Guide for the instructions to
and module name,		configure the switch using CLI commands.
etc.) were lost		If the problem continues, contact Enterasys Networks for
when the switch
		technical support.
power was cycled.

Using the Reset Switch

If you forget the switch login password, use the Reset switch to reset the login password to the default password, as described in the following procedure.

Figure 4-3 Reset Switch

À

1Reset switch

4-8 Troubleshooting