12CHAPTER 2: INSTALLING THE ETHERNET ADAPTER
Figure 3 shows the front view of the Ethernet Adapter, including the LEDs and connecting ports. It also shows the cradle, which is used to mount the Ethernet Adapter to a wall or to install the Ethernet Adapter on a flat surface.
Figure 3 Ethernet Adapter
11a/b/g Wireless Ethernet Adapter
Power Port
Serial Port
Ethernet Port
Observing Safety This equipment must be installed in compliance with local and national
Precautions building codes, regulatory restrictions, and FCC rules. For the safety of people and equipment, only professional network personnel should install the Ethernet Adapter.
WARNING: To comply with FCC radio frequency (RF) exposure limits, a minimum
WARNING: To avoid possible injury or damage to equipment, you must use either the provided power supply or power supply equipment that is safety certified according to UL, CSA, IEC, or other applicable national or international safety requirements for the country of use. All references to power supply in this document refer to equipment meeting these requirements.
WARNUNG: In Übereinstimmung mit den von der FCC (Federal
Communications Commission) festgelegten Grenzwerten für die
Einwirkung von Radiowellen muss bei Betrieb des
Abstand zwischen Körper und Antenne 20 cm betragen.
WARNUNG: Zur Vermeidung möglicher Verletzungen oder Schäden am Gerät muss entweder das mitgelieferte Netzteil oder ein Netzteil verwendet werden, das von der UL (Underwriters Laboratories Inc.), CSA
