Maintaining and Transporting the Printer
4.Press the Enter button. The nozzle check prints as shown below.
If all the lines in the check pattern are complete, with no gaps or misplaced dots, the print head doesn’t need cleaning. (You may need to use an eye loupe to check the pattern.)
If any dots are out of place or missing from the pattern, as shown below, clean the print head as described in the next section.
Caution
Don’t run a cleaning cycle while thick media is loaded in the printer.
Cleaning the Print Head from the Control Panel
Follow these steps to run the cleaning cycle from the printer’s control panel:
1.Print a nozzle check to make sure the print head needs cleaning.
2.Make sure that all of the H Ink Out lights on the printer’s control panel are off.
If an H Ink Out light is flashing or on, you need to replace the corresponding ink cartridge instead. See page
3.Press the Cleaning button and hold it for at least 3 seconds. The Pause light flashes as the printer cleans its print head. The cleaning cycle takes about 60 seconds and does not use any paper.
4.When the Pause light goes off, print the nozzle check again to confirm that the head is clean.
You may need to run the cleaning cycle several times until the nozzle check pattern is correct. For effective cleaning, always print a nozzle check pattern between cycles.