Page length does not match the length of the paper.

Change the page-length setting with DIP switches 2-1 and 2-2. See page 3-10.

Check the page length set by your software and adjust it if necessary.

Regular gaps occur in the printout.

One-inch skip-over-perforation may be set. Set DIP switch 1-8

off.

Skip-over-perforation is set, but the perforation does not fall inthe center of the skip.

Make sure the page-length DIP-switch setting matches the page length of your paper. See page 3-10.

If your software controls the top and bottom margins, set DIP switch 1-8 off.

Vertical printed lines do not align.

Turn DIP switch 1-5 on for unidirectional printing.

Printing starts too low on the page, or the bottom part of one pageis printed at the top of the next page.

Be sure to choose the correct printer when you choose a printer from your software’s setup menu. See page 1-15.

Use your software to specify the type of paper you are using (single-sheet or continuous).

6-6Troubleshooting