Check that the paper-thickness lever is set correctly for the paper you are using. See page 2-24.

Check that paper size and thickness are within the specified range. See page 74.

Paper loaded from the cut-sheet feeder is crooked.

The paper may be old or creased. Use onIy new, clean sheets of paper.

There may be too much paper in the stacker. Remove the paer from the stacker.

Make sure that your paper is the proper size and quality. See Chapter 7.

Paper loaded with the optional pull tractor is crooked or the paperjams.

The pull tractor and push tractor sprocket “units may not be aligned correctly. Make sure the sprocket units on both tractors are aligned.

There may be slack in the paper. Adjust the position of the sprocket units to take up any slack across the width of the paper. Remove slack lengthwise by pulling out and rotating the gear on the right of the optional pull tractor.

Single-sheet paper does not fully eject.

Use the LOAD/EJECT button to eject paper. Do not use the

LF/FF button.

The paper may be too long. Only use paper that is within the specified range. See page 7-4.

6-10 Troubleshooting