Multi-part forms
Your printer can print on both single-sheet and continuous multi- part forms. You can load single-sheet multi-part forms only in the front paper slot.
You can use multi-part forms of up to four parts (including the original). Make sure you set the paper-thickness lever to the proper position. Use only carbonless multi-part forms.
You load multi-part forms the same way as you load single sheets or continuous paper. For best results with continuous multi-part forms, it is recommended you use the tractor installed in the push-tractor position together with the optional pull tractor.
For details, see “Using Single Sheets” or “Loading continuous paper with the pull tractor,” earlier in this chapter. Pay special attention to setting the loading position as described in “Using micro-feed” in Chapter 3.
Caution:
When printing multi-part forms, make sure the printing stays entirely within the printable area of the forms. (For more information on the printable area, see Chapter 7.)
Use four-part multi-part forms only under normal operating conditions.
Load single-sheet multi-part forms from the front only.