3.Press the orange P Power button on top of the projector—or press the P Power button on the remote control.

(If this is your first time using the remote control, make sure the batteries are installed; see page 43.)

Power button

The P Power light flashes green as the projector warms up, and an image begins to appear. When the P Power light stops flashing and remains green (in about 20 seconds) the projector is ready for use.

4.If you’ve connected a Windows-based computer to the projector, you may see a New Hardware Wizard saying your computer has found a plug-and-play monitor; if so, click Cancel.

note

If the Direct Power On feature has been enabled, you don’t need to press the

PPower button to turn the projector on. Just plug the projector into an electrical outlet. When the

PPower light stops flashing and stays on, the projector is ready to use.warning

Never look into the lens when the lamp is on. This can damage your eyes, and is especially dangerous for children.

Projecting 29