note
You can also set up your image as a startup screen. Use the Advanced menu to enable the startup screen; see
6.When you see the message “Do you use this image?” select Yes and press Enter. If you want to change the area selected, select No, press Enter and repeat steps 4 through 6. You see the message shown at the left.
7.Use the arrow buttons on the control panel or the Enter button on the remote control to select a zoom rate (display size), and then press Enter.
8.When the message “Do you save this image?” appears, select Yes and press Enter.
Saving the logo may take a few moments. Do not use the projector or other sources (computer, video, speaker, etc.) while the logo is being saved.
9.When you see the message “Saving the user logo is completed,” press the Menu or Enter button to return to the Capture menu. Then press Esc to return to the main menu.
Setting Up When the Image DisplaysAfter your image is saved, you can set it up as the
1.Press the Menu button to display the main menu (if not already displayed).
2.Press the down arrow (control panel) or press down on the Enter button (remote control) to highlight the Setting menu.
3.Press the Enter button to select the Setting menu.
4.Press the down arrow (control panel) or press down on the Enter button (remote control) to highlight
5.Press the right arrow or use the Enter button to select Logo. This sets your image as the screen displayed when the projector is not receiving a signal.
6.If you want to set up your image as the A/V Mute display, use the down arrow or Enter button move down to A/V Mute.
50