Connecting to a Desktop Macintosh

You can connect the projector to any desktop Macintosh. This section includes instructions for the following:

Connecting the computer video cable and computer monitor cable

Connecting the mouse cable (if you want to use your remote control as a mouse)

Connecting the audio cable (if you’ll be projecting with audio)

Follow the steps in each section for the cables you need to connect. Before beginning, turn off the projector and computer if they are on.

Connecting the Computer and Monitor Cables

This illustration shows the connections you’ll be making. (You may not need to use the adapters as shown.) For details, follow the steps below.

Macintosh desktop adapter (if needed)

Macintosh monitor adapter (if needed)

Macintosh monitor cable

computer cable

1.Disconnect the monitor cable from the video port on the back of the Macintosh.

2.Connect one end of the computer cable to the projector’s Computer 1 port, as shown.

note

Macintosh configurations vary. See your computer manual for the location of the ports needed to connect your projector. Older models may require a Macintosh adapter set, which you may purchase from EPSON; see page 8.

Appendix A: Connecting to Additional Equipment 83