To install EMP Link V, insert the Projector Software CD-ROM in your CD-ROM drive and follow the instructions on the screen. The installation program also installs the EMP Link V User’s Guide on your hard disk. You can access this manual in the EMP Link V folder for complete instructions on using the program.

Connecting to an External Audio System

The projector’s internal speakers are loud enough for most rooms. However, if your installation requires maximum volume and sound quality, you can connect the projector to external speakers or a public address (PA) system. If you’ve connected multiple audio and video sources to the projector, the projector will automatically switch the audio source along with the video source whenever the user chooses a different video source. (See “Switching Between Picture Sources” on page 27 or page 32.)

To connect the projector to an external sound system, you will need an RCA-to-3.5 mm stereo audio cable, which may be included with your sound system, or may be purchased from an electronics store.

Before you start, make sure the projector and speakers or PA system are turned off.

1.Connect the cable’s 3.5-mm stereo miniplug to the projector’s

Audio Out jack.

audio cable

2.Connect the RCA plugs to the speaker or PA system. Insert the cable’s red plug into the Audio R jack, and the white plug into the Audio L jack of the external speaker system.

Appendix A: Connecting to Additional Equipment 79