You have been using your hard disk drive successfully for some time but notice a redduction in performance.
The data on the disk may have become fragmented. Back up all your data and use a disk compaction utility to reorganize the files on your disk.
If you cannot access data on your hard disk or you are seeing read/ write errors, the disk may have a physical problem. Contact your service representative.
Password Rob/ems
You have forgotten your password.
You must discharge your CMOS memory. To do this, you need to change the setting of jumper 537 to position
After you have changed J37, restart the computer, leave it on for a few seconds, then turn it off again. This resets the SETUP values to their factory defaults. Both the Supervisor and the User passwords are disabled.
Set J37 back to position
You see a diskette access error message.
You may have set the Diskette Access option in SETUP to Supervisor but have logged onto your system using a User level password. See Chapter 2 for information about setting the Diskette Access option and using Supervisor and User passwords.
Troubleshooting 6- 9