You can change the processor speed temporarily by entering one of the following commands from the numeric keypad on your keyboard :

0To select slow speed, press Ctrl Alt and then press the -key on the numeric keypad. This turns off the speed light.

0To select fast speed, press Ctrl Alt and press + on the numeric keypad. The speed light comes on.

Note

You can use the commands listed above while you are running a program. However, if the program uses one of these commands for another function, you cannot use it to change the processor speed.

The speed setting remains in effect until you one of do the following:

0 Reset your computer

0 Turn off your computer

0 Change the speed with another keyboard command

0Change the jumper setting of J25 (as described in Chapter 4).

Using Your Computer 3- 7