5.Secure the bracket to the drive with four screws

Note

If you plan to install two hard disk drives, you must use flat-head screws to secure the second drive to the mounting bracket. You can purchase flat-head screws at any hardware store; request this size: #6-32UNC x 8 FH, M,+. Also, make sure you set the jumpers on both hard disk drives to indicate which is the master and which is the slave drive. See the documentation that came with your drive for instructions.

6.Turn the drive and the mounting bracket over, then slide the slots in the mounting bracket under the tabs at the base of

the computer until the tabs hold the bracket in place.

7.Secure the mounting bracket with the retaining screw.

Note

If the drive does not fit within the internal bay, you can move the mounting frame toward the diskette drive bays and align only one set of the slots on the mounting bracket with the tabs on the computer. In this case, you insert the retaining screw in the front slot on the mounting bracket as shown in the following illustration.

5-12 Installing and Removing Drives