3.Locate the multi-colored power supply cable with the small connector. This cable is attached to the system board rather than the power supply.

4.Position the power supply cable connector so that the holes fit over all the pins. The red wire on the cable will align with pin 1 identified at the power connector on the circuit board of the drive. Push in the connector.

Caution

If you do not align the cable connector correctly, you could severely damage your hard disk drive when you push it in.

Post-installation Procedures

After you install or remove your drive(s) and replace the cover on your computer, you need to run the SETUP program to define the correct configuration for your newly installed drive. See Chapter 2 for instructions.

5-20 Installing and Removing Drives