3.Reach behind the drive and gently push it to the front of the bay; then pull it out of the slot.
4.Once you have removed the drive, replace the faceplate by inserting one side of the plate, then gently guiding the other side into place. You will hear it snap into place.
Reconnecting the Drive and Power Cables to the Diskette Drive in the Lower Drive Bay
If you had to disconnect the drive and power cables from the diskette drive in the lower bay, refer to the illustration below while you follow these steps to reconnect the cables:
1. Locate the connector on the diskette drive ribbon cable.
2.Identify pin 1 on the drive and align the connector so that the red wire is at pin 1, as shown below. Push in the connector.
r e d w i r e
Installing and Removing Drives |