4.Position one of the cache chips over the first socket as shown below, aligning the pins on the chip with the holes in the socket. Make sure the small notch on the end of the chip is aligned with the corresponding notch on the socket.

5. Gently

press the chip halfway into the socket (to make sure

it is correctly aligned). If the chip goes in at an angle,

remove

it and try again.

6.When the chip is properly positioned, push down firmly on both ends of the chip to make sure it is well-seated.

7Repeat steps 4 through 6 for each of the remaining chips.

8 Change jumpers

526,527,528,

and

J29 as described on page 4-8,

to correspond to

the amount

of

cache you installed.

9Replace any option cards you removed. See page 4-14 for instructions.

Installing and Removing Options

4-25