Power-on diagnostics error messages (continued)

Error message

Action

 

 

DISPLAY SWITCH IS

Jumper J5 conflicts with the video options in the

SET INCORRECTLY

SETUP program. See Chapter 2 of the User’s Guide

 

 

for correct jumper settings and Chapter 2 of the

 

 

Setup Guide for instructions on running SETUP.

 

 

DISPLAY TYPE HAS

The display adapter has been changed. Run

CHANGED SINCE

SETUP. See Chapter 2 of the Setup Guide.

LAST BOOT

 

 

 

FLOPPY DISK

The system was unable to detect a diskette drive

CONTROLLER ERROR

controller.

OR NO

 

 

CONTROLLER

If you have no diskette drive, run SETUP and select

PRESENT

 

none for both diskette drives.

 

 

If you have at least one diskette drive, see

 

 

,, Diskette Drive Problems. ”

 

 

FLOPPY DISK TYPE IS

The installed diskette drive does not match the

SET INCORRECTLY

CMOS definition. See “Diskette Drive Problems.”

OR DRIVE ERROR

 

 

 

HARD DRIVE

The system was unable to detect the hard disk

CONTROLLER

drive controller. See “Hard Disk Problems,”

DIAGNOSTICS ERROR

 

 

 

HARD DRIVE SECTOR

Your hard disk drive may be damaged. Contact

VERIFY ERROR

your Authorized Epson Servicer.

 

 

KEYBOARD ERROR

Your keyboard may not be connected correctly,

OR NO KEYBOARD

See “Keyboard Problems.”

PRESENT

 

 

 

 

 

MEMORY

ERROR

Your SIMMS may not be installed correctly. See

DURING

MEMORY

“Memory Module Problems.”

TEST

 

 

 

 

NON-SYSTEM DISK

The system cannot boot from the diskette. Make

OR DISK ERROR

sure the diskette is bootable and see

 

 

*Diskette Problems. ”

 

 

 

Troubleshooting 6-5