4.Push the SIMM into the socket until it is seated firmly in the slot. Then tilt it upright, as shown below, guiding the hole at each end of the SIMM over the retaining post at each end of the SIMM socket.
If it does not go in smoothly, do not force it; pull it all the way out and try again.
5.Repeat steps 3 and 4 for the second SIMM.
6.Replace any option cards you removed. See page
7.The next time you turn on your computer, run the SETUP program so your computer can update its configuration information with the new memory. See Chapter 2 of the Setup Guide for instructions.