If you set a System Access password when you ran the SETUP program, you must enter it every time you turn on or reset the computer. Follow these steps to use your password:
1.If you do not have a hard disk, insert your system diskette in drive A.
2.Turn on or reset the computer. You see the following prompt:
Enter Password:3.Type your password. You see an asterisk for each character you type. Then press [Enter].
After you type the password correctly and press [=I, the computer loads the operating system and displays the command prompt.
Note
If you do not know the correct password, see “Password Problems” in Chapter 6.
Changing or Deleting a Password
To change or delete your password, you must run the SETUP program and follow the instructions for entering a password in Chapter 2 of the Setup Guide.
If you do not know your password, see “Password Problems” in Chapter 6.
Using Your Computer