Epson FX Paper separator, Printer Preparation, Figure 1-3.Paper path, Note: The printer should be turned OFF during all set-upoperations

Figure 1-3. Paper pathPrinter Preparation

Once you’ve found a good home for FX, you’ll need to do some preparing before you can print. This section describes the first steps, which include installing a few parts, checking the setting of some internal switches, and then inserting the ribbon cartridge.

Note: The printer should be turned OFF during all set-up operations.Paper separator

To install the paper separator, hold it vertically so that it rests on the two slots at the back of the metal frame as shown in Figure 1-4.Press down gently but firmly until the separator snaps into place.

To remove the separator, pull up on the left side first, letting the right side slide out of its slot.

17