Plugging In the Scanner | Epson GT-5500 instruction

Plugging In the Scanner

1.Make sure that the scanner is turned off. It is off when the OPERATE button protrudes from the surface of the front panel.

OPERATE

RESET

2.Connect the power cable to the power inlet on the rear of the scanner and plug the other end into a properly grounded

outlet.

SCSI	* 0	1
7		2

63

5 4

SCSI

ON

SW

cCaution:

It is not possible label on the back voltage for your

to change the scanner’s voltage. If the of the scanner does not show the correct country, contact your dealer.

1-4Setting Up the Scanner

Image 16

Epson GT-5500 manual Plugging In the Scanner

Contents

Page Scanner Parts GT-5500 Declaration of Conformity Contents Appendix a Technical Specifications Glossary Index Page Introduction FeaturesOptions Scsi System Cable 25-pin to 50-pin B860081 Important Safety InstructionsScsi Peripheral Cable 50-pin to 50-pin B860091 Introduction Safety information For United Kingdom Users Setting Up the Scanner Choosing a Place for the Scanner Removing the Transportation Screw Plugging In the Scanner Initialization Understanding Scsi connections Connecting the Scanner to Your ComputerDaisy Chain Setting the Scsi ID number Scsi CablesPage Do not use an external terminator Connecting the scanner CCaution Power-on sequence Power-off sequence For Windows 95 users Using Your Scanner Lights and Buttons Lights Placing a Document on the Scanner Before scanning a document Corner of the document Removing the Cover for Thick or Large Documents Do not place heavy objects on top of the scanner Sizing Up Your System RAM and hard disk size Accelerator boards Video cardsMonitors File compression software Maintenance and Troubleshooting Maintenance Cleaning the scanner Transporting the Scanner Replacing the fluorescent lamps Problems and Solutions Error indicators Operating problems Operate light does not come onReady light does not come on Scanner does not start scanning Scanner software does not work properly Quality problems Entire image is distorted or blurredPart of the image is distorted or blurred Edges of the document are not scanned Image is faint or out of focus Image is too darkStraight lines in the image are jagged Image does not look the same as the original Line of dots is always missing in the scanned image Printed image is larger or smaller than the original size Your image cannot be printed or the printout is garbled Technical Specifications 2Technical Specifications Scanning Electrical Safety Approvals Environmental Scsi Interface Initialization Methods Contacting Customer Support Contacting Customer Support For United Kingdom and the Republic of Ireland Users Enquiry Desk Customer Support For Australian Users Epson Faxback For Singapore Users For Hong Kong Users For Philippines Users Electronic bulletin board system Glossary Additive primary colors ESC/I Scsi Threshold Index Index IN-1 IN-2 Index Index IN-3 IN-4 Index Epson Overseas Marketing Locations Epson AMERICA, INC