Removing the Transportation Screw
Before connecting the scanner to a power source, you must remove the transportation screw.
1.Place the scanner on a flat, stable surface with its rear panel facing you.
2.Remove the screw located in the middle of the rear panel by turning it
SCSI | * | 0 | 1 |
| 7 |
| 2 |
| 6 | 5 | 4 3 |
|
|
SCSI |
ON
SW
3.Push the screw into the storage hole marked STOCK. It does not screw in. Make sure you push it all the way into the hole.
SCSI | * | 1 |
|
| 0 |
7 |
| 2 |
63
5 4
SCSI |
ON
SW
Note:
Do not discard the transportation screw. It must be replaced when storing or transporting the scanner.
Setting Up the Scanner
