LCD screen message

Condition/solution

Recovery mode

An error has occurred during firmware updating. Connect your product using

 

a USB cable and try updating the firmware again. If you still receive this error

 

message, contact Epson for support.

Note: The ink pads in the printer collect, distribute, and contain the ink that is not used on printed pages. During the life of your product it may reach a condition where either satisfactory print quality cannot be maintained or the ink pads have reached the end of their usable life. The Epson Status Monitor, your LCD, or lights on the control panel will advise you when these parts need replacing. If this happens during the standard warranty of the product, the exchange of the product or replacement of the pads is covered under the standard warranty. If the product is out of warranty, the pads can be replaced by any Epson authorized service provider. The waste ink pads are not a user-replaceable part.

Parent topic: Solving Problems

Related references

Paper Jam Problems Inside the Product

Paper Jam Problems in the Paper Cassette

Paper Jam Problems in the Auto Duplexer

Where to Get Help

Related tasks

Using AirPrint

Selecting the Paper Settings for Each Source - Control Panel

Related topics

Loading Paper

Using Memory Cards With Your Product

Wi-Fi Networking

Running a Product Check

Running a product check helps you determine if your product is operating properly.

1.Disconnect any interface cables connected to your product.

2.Load plain paper in the product.

3.Press the home button, if necessary.

4.Press the arrow buttons to select Setup and press the OK button.

249

Page 249
Image 249
Epson XP-620 manual Running a Product Check, Related references