Epson XP-620 Solving Setup Problems, Noise After Ink Installation, Software Installation Problems

4.Select one of these options:

•Network Settings: Resets all network settings.

•All except Network Settings: Resets all control panel settings, except for network settings.

•All Settings: Resets all control panel settings.

You see a confirmation screen.

5. Select Yes to reset the selected settings. (Select No if you want to cancel the operation.)

Parent topic: Solving Problems

Solving Setup Problems

Check these sections if you have problems while setting up your product.

Noise After Ink Installation

Software Installation Problems

Control Panel Setup Problems

Parent topic: Solving Problems

Noise After Ink Installation

If you hear noises from your product after installing ink, check the following:

•The first time you install ink cartridges, the product must prime its print head. Wait until priming finishes before you turn off the product, or it may prime improperly and use excess ink the next time you turn it on. Your product is finished priming the print head when the power light stops flashing.

•If the product's print head stops moving or making noise, and the charging process has not finished after approximately 5 minutes, turn off your product. Turn it back on and check to see if charging is still in progress. If it is still in progress, contact Epson for help.

Parent topic: Solving Setup Problems

Software Installation Problems

If you have problems while installing your product software, try these solutions:

•Make sure your product is turned on and any necessary cables are securely connected at both ends. If you still have problems installing software, disconnect the cable and carefully follow the instructions on the Start Here sheet. Also make sure your system meets the requirements for your operating system.

•Close any other programs, including screen savers and virus protection software, and install your product software again.

252