Ericsson LBI-39076B system manual Who Can Receive Calls

CONFIGURATION LBI-39076B

∙Line Active - This column of parameters defines (for the site) if a line is available for interconnect calls. Default is no (N) for all lines. Enter Y for yes, or leave N for no. Note that a line number gets its number from the radio channel number that shares the same GTI Unit. Also note that GTI Units are placed on the highest available channel numbers first.

Line Definition (menu selection 14) Line Parameters (pages 1 & 2)

∙Pulse Dial - This column of parameters defines (for the site) if a line uses pulse dialing. Default is no (N) for all lines. Note that the ELI system will ignore this parameter, so there is no point in changing it from its

default value. However, the equivalent of this parameter must be set in the GTI user database. (See the GTI Configurator Software user’s guide, LBI- 39077.)

Line Definition (menu selection 14) Line Parameters (pages 1 & 2)

∙Message Conv Limit - This 4-digit field defines (for the site) the conversation time limit(in seconds) for interconnect calls (and message trunking). Default is 300 seconds. Enter a number from 10 to 2550.

Site/Device Definition (menu selection 10) Site Parameters (panel 2)

Channel Assignment Parameters

∙Interconnect Hang Time - This 2-digit field defines (for the site) the time (in seconds) between an unkey command and channel drop. Default is 30 seconds. Do not enter a number larger than 60 (see note).

Site/Device Definition (menu selection 10) Site Parameters (panel 2)

Channel Assignment Parameters

NOTE

Although the Interconnect Hang Time (IHT) can be set higher than 60 seconds, the GTI unit will wait no more than 60 seconds for a telephone- originated call to be answered. Therefore, setting the IHT to more than 60 seconds will not allow more than 60 seconds for the call to be answered.

NOTE

The voice prompt played to the caller (as the result of an unanswered telephone-originated call) will depend upon whether the IHT or the 60-second GTI interval expires first. If the IHT is set to less than 60 seconds, it will expire first and the GTI unit will play voice prompt #6. (Default = Call is disconnecting) If the IHT is set to more than 60 seconds, the 60-second GTI interval will expire first and the GTI unit will play voice prompt #5. (Default = Radio didn’t answer) If the IHT is set exactly to 60 seconds, either voice prompt #5 or #6 may be played, due to slight timing variances.

∙Max # Concurrent Intercon - This 2-digit field defines (for the site) the maximum number of simultaneous telephone interconnect calls permitted. Default is 2.

Site/Device Definition (menu selection 10) Site Parameters (panel 2)

Channel Assignment Parameters

Who Can Receive Calls

∙Inb Interconnect - This 1-digit field defines (for each logical unit ID) if inbound interconnect calls are allowed for this specific logical unit ID. Default is no

(N). Enter Y for yes, or leave N for no.

Logical Unit Definition (menu selection 11) Radio Parameters (panel 2)

Radio Features

∙Inb Interconnect - This 1-digit field defines (for each group ID) if inbound interconnect calls are allowed for this specific group ID. Default is no (N). Enter Y for yes, or leave N for no.

Group Definition (menu selection 12) Group Parameters (panel 2)

Features

31