Extron electronic 12800 manual Pre-virtualization operations, BME settings

K L M N O P

Balanced and unbalanced audio input connectors — See page 2-13.Audio outputs connectors — See page 2-14.

FPC Comm port — (FUTURE CAPABILITY) MCP/MKP Comm ports — See page 2-14.Ethernet port — See page 2-15.

External Sync connectors — See page 2-16.

Pre-virtualization operations

BME settings

A	BME address switch — Each BME must be set to a unique address of 0
	through 8. Address 9 is invalid. The addresses used in the system must be
	sequential with no skipped numbers, other than as required for audio BMEs.
	Audio BMEs occupy two BME addresses: the set address and the set address
	plus 1 (for example, if the audio BME is set to address 3, it occupies addresses
	3 and 4). Set the next BME after the audio BME to the address number plus 2
	of the audio BME (for example, if the audio BME is set to address 3, set the
	next BME to address 5).
	Sync BMEs cannot be set to address 0.
	To set the BME address, press the + and - buttons on the BME Address switch
	on the rear panel of the switcher (figure 2-2).

	BME	CPU STATUS
1	-
		PRIMARY	IN
	4
	+	REDUNDANT
	ADDRESS		SYNC
	POWER SUPPLIES
	+V	-V	OUT
		PRIMARY
		REDUNDANT
	PRIMARY AC		REDUNDANT AC
	POWER INPUT		POWER INPUT
		FUSE 250V 5.0A T	FUSE 250V 5.0A T	BEFORESERVICING.
		MAX 50/60Hz	MAX 50/60Hz	POWER CORDS
		5.0A	5.0A	BOTH
		100-240V	100-240V	DISCONNECT

BME 4 ADDRESS

BME
4			CPUS
					TA
					TUS
ADDRESS				PRIMARY
				REDUND
+v	PO	WER				ANT
					SUPPLIES				IN
	-v
POPRIMAR				PRIMARY					SYNC
WER		YREDUND				ANT
				AC
		INPUT				REDUN
								DA	OU
						PO			T
							WER		NT AC
								INPUT

0.5A MAX 50/60Hz	MAX 50/60Hz
-240V	0.5A
100	-240V
	100

	MADEANAHEIM,						CA
				IN
						USA
F	CA
or
fire,prote		UTIO
type		ction				N
	replace		onlyagainstr
	and
		rating					th	isk
						wi		samof
					of
							fuse.		e

Figure 2-2 — Setting a BME address

Matrix 12800 Switchers • Installation 2-5