Extron electronic Rear Panels, IPL T PC1 Rear Panel 120 VAC, IPL T PC1i Rear Panel 220 VAC

Rear Panels

1		2	3
100-120VAC	50/60Hz	MAC ADDRESS
			COM
			TX RX	+5V
			INPUT	IR
12A MAX		POWER OUTPUT 12A MAX	IN	S G
		7	6	5

® US

LISTED 17TT

AUDIO/VIDEO

APARATUS

LAN

4

Figure 2. IPL T PC1 Rear Panel (120 VAC)

1 2 3

200-240VAC	50/60Hz	MAC ADDRESS
			COM
			TX RX	+5V
			INPUT	IR
10A MAX		POWER OUTPUT 10A MAX	IN	S G
		7	6	5

LAN

4

Figure 3. IPL T PC1i Rear Panel (220 VAC)

APower connector — Connect a power cord from a wall outlet to this male IEC power receptacle.

BUID label — Contains the unique User ID number (MAC address) of the unit (for example, 00-05-A6-00-00-01).

CCOM port (RS-232)— Connect the output device serial port to this captive screw connector to enable bidirectional RS-232 device control. This serial port contains the

following four pins, in order from left to right on the rear panel: transmission (Tx), receiving (Rx), ground (_), and +5 V (to tie hand-shaking lines on the controlled device if needed).

DLAN connector and LEDs — An Ethernet connection can be used on an ongoing basis to monitor and control the PC1 and the device connected to it (see “Wiring the Local Area Network (LAN) Port” for instructions on connecting the host to this port).

•RJ-45 port — Plug a patch cable into this RJ‑45 female socket, and connect the other end to a network switch, hub, router, or computer.

•Link LED — This green LED lights to indicate a good network connection.

•Activity LED — This yellow LED blinks to indicate network activity.

LAN

RJ-45

Port

Link

LED

Activity

LED

IPL T PC1 • Installation and Rear Panels 5