Extron electronic IPL T PC1i Password Information, Error Responses, Error Response References

Password Information

The ] Password: prompt is displayed only if there is a password defined in the unit. It requires a password (administrator level or user level) followed by a carriage return. The prompt is repeated if the correct password is not entered.

If the correct password is entered, the unit responds with ] Login Administrator ] or ] Login User ], depending on the password entered. If the passwords are the same for both administrator and user, the unit defaults to administrator privileges.

Error Responses

When the PC1 receives a valid SIS command, it executes the command and sends a response to the host device. If the PC1 is unable to execute the command because the command is invalid or it contains invalid parameters, it returns an error response to the host.

The error response codes and their descriptions are as follows:

E12 – Invalid port number

E13 – Invalid value (the number is out of range/too large)

E14 – Not valid for this configuration

E17 – System timed out

E22 – Busy

E24 – Privilege violation

E25 – Device is not present

E26 – Maximum number of connections has been exceeded

E27 – Invalid event number

E28 – Bad filename or file not found

E30 – Hardware failure (followed by a colon [:] and a descriptor number)

E31 – Attempt to break port pass-through when it was not set

Error Response References

The following superscripted numbers are used within the command descriptions in the Command and Response table to identify commands that may respond as shown:

14	=	commands that give an E14 (invalid command for this configuration) response if
		sent to an IPL product whose power configuration does not support the command.
24	=	commands that give an E24 (privilege violation) response if you are not logged in at
		the administrator level.
27	=	commands that may yield an E27 (invalid event number) response.
28	=	commands that may give an E28 (file not found) response.

IPL T PC1 • SIS Programming and Control 48