Extron electronic IPL T PC1i manual W X# Cz, IPL T PC1 SIS Programming and Control

Command	ASCII (Telnet)	URL Encoded (web)	Response
	(Host to Switcher)	(Host to Switcher)	(Switcher to Host)
IP Setup Commands (continued)
Set GMT offset24	E X# CZ}	W X# CZ	Ipz X# ]
View GMT offset	E CZ}	W CZ	X# ]
Set daylight savings time24	E X3$ CX}	W X3$ CX	Ipx X3$ ]
View daylight savings time	E CX}	W CX	X3$ ]
Set DHCP on24	E 1DH]	W 1DH	Idh1 ]
Set DHCP off24	E 0DH]	W 0DH	Idh0 ]

NOTE: Changing DHCP from On to Off resets the IP address to the factory default (192.168.254.254).

View DHCP mode	E DH]	W DH	X% ]
Set IP address24	E X1$ CI}	W X1$ CI	Ipi• X1$ ]
View IP address	E CI}	W CI	X1$ ]
View hardware (MAC) address	E CH}	W CH	X1* ]
			With tagged response –
			verbose modes 2 and 3:
			Iph• X1* ]
Set subnet mask24	E X1( CS}	W X1( CS	Ips• X1( ]
View subnet mask	E CS}	W CS	X1( ]
Set gateway IP address24	E X1$ CG}	W X1$ CG	Ipg•X1$ ]
View gateway IP address	E CG}	W CG	X1$ ]
Set verbose mode24	E X2@ CV}	W X2@ CV	Vrb X2@ ]

NOTE: The IPL T PC1 can send out unsolicited information (such as notice of a power level change). This is called a

verbose (wordy) relationship between the interface and a connected device. When the IPL T PC1 is connected to the computer via Ethernet, verbose mode is disabled (by default) in order to reduce the amount of communication traffic on the network. If you want to use the verbose mode with the PC1 connected via Ethernet, you must set

verbose mode to On each time you reconnect the computer to the network.

View verbose mode status	E CV}	W CV	X2@ ]
Set broadcast mode	E X6$,X1$ EB}	W X6$ %2C X1$ EB	Bmd
Set broadcast mode to default	E X6$ EB}	W X6$ EB	Bmd X6$,X1$ ]
address
Clear broadcast mode	E 0EB}	W 0EB	Bmd 000,X1$ ]
View broadcast mode	E EB}	W EB	X6$,X1$ ]
Set broadcast port and MAC	E port number* X7!*X7@ PB}
address
		W port number* X7!*X7@ PB
			Bpt port number*X1* ]
View broadcast port and MAC	E PB}	W PB	port number*X1* ]
address

NOTE: Port number is the UDP outgoing port. X7!*X7@ is the MAC address for UDP unicast transmissions.

Get connection listing	E CC}	W CC	Number of
			connections ]
			With tagged response –
			verbose modes 2 and 3:
			Icc Number of
			connections]

IPL T PC1 • SIS Programming and Control 57