Extron electronic IPL T PC1i manual Part Numbers and Accessories, Mounting the IPL T PC1 Interface

Part Numbers and Accessories

Included Parts

These items are included in each order for an IPL T PC1 or IPL T PC1i interface:

Included Parts

Part Number

IPL T PC1	60-544-10
IPL T PC1i	60-544-20
Rubber feet (self-adhesive) (4)
2-pin female captive screw terminal (2)
4-pin female captive screw terminal (1)
18 AWG IEC power cord (U. S. shipments only)
Tweeker (small screwdriver)
IPL T PC1 Setup Guide
IPL T PC1 Software CD-ROM

Optional Accessories

These items are optional for the IPL T PC1 and the IPL T PCli:

Optional Accessories		Part Number
RSU 129 Universal Rack Shelf Kit (9.5 inches deep)		60-190-01
RSB 129	Basic Rack Shelf (9.5 inches deep)	60-604-02
RSU 126	Universal Rack Shelf Kit (6 inches deep)	60-190-10
RSB 126	Basic Rack Shelf (6 inches deep)	60-604-11
MBU 125 1/2 Rack Width Low-Profile Mount Kit		70-077-01

Mounting the IPL T PC1 Interface

The IPL T PC1 can be set on a table, mounted on a rack shelf, or mounted under furniture such as a desk, podium, or tabletop.

Tabletop Use

Four self-adhesive rubber feet are included with the PC1. For tabletop use, attach one foot at each corner of the bottom side of the unit, and place the PC1 in the desired location.

Rack Mounting

Rack mount the interface, if desired, using one of the optional 19 inches wide rack shelves (see “Optional Accessories,” above, for part numbers).

UL requirements for rack mounting

The following Underwriters Laboratories (UL) requirements pertain to the installation of the interface into a rack.

•Elevated operating ambient temperature — If the equipment is installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack environment may be greater than room ambient temperature. Therefore, consider installing the equipment in an environment compatible with the maximum ambient temperature (TMA) specified by the manufacturer.

IPL T PC1 • SIS Programming and Control 64